View Full Version : AK 427 console


Dave A
05-30-2012, 09:22 PM
From a mention in the BW forum, I moved this VK find to here. Not a great find but cheap fun. Power up later.

A local CL find in S Phila. Early 30's AC set. Very economy lowboy. Family piece that no one wanted to keep. Just as pretty as it looks. 7 tubes, AM/SW. Chassis is held in by a wood plug. No screws. And what is that switch on the back? Antenna connections are local/distant by the instructions inside the cabinet.

Pix not loading right now...stay tuned.

Dave A
05-31-2012, 08:02 PM
Got the pix to load. (Mods - had to do them one at a time).

An AM/SW two-band. Only up to about 3.5mhz.

Tuner drive is a rubber ring on the tuning control which rubs against a toothed plate behind the dial. Rubber is gone. About a piece of 3/8" rubber hose should do it.

A look underneath is interesting. Someone tied the local/distant antenna leads to ground. The shielded wire to the T1 coil which used to carry the L/D wires is also tied to the same ground. The proper ground is still in place.

And a headset pin connection was added via a switch off of the 2nd detector. You can see it on the back. That will go away.

Some hard rubber wire needs changing. A large potted container with 11 caps needs checking. Mostly .0x caps.

Volume control is all but frozen. Soaking right now.

And if anyone has a donor cabinet, I could use a little ornate trim piece. About 4" long near the top on the right.

7"estatdef
06-01-2012, 08:06 AM
Hi Dave
I saw that set too.Good price. I'm in Roslyn but I need another radio like a hole in the head.I've got a nice AK 206 that needs a good going over + all that rubber wire.
GL
Terry

7"estatdef
06-01-2012, 12:13 PM
...

DavGoodlin
06-01-2012, 08:03 PM
While wee talking AK, I have a friend near Ephrata with a Highboy. Could not pull it outto see model # but looks like a 55 or a 72.