All the tests seem to work ok EXCEPT for the emission testing. Even with a known good crt I get no reading at all on my meter. can some one walk me through the troubleshooting procedure for this problem?thanks:scratch2:

The selector switch could be dirty or broken. You will have to take a look inside.

Perhaps this calibration proccedure would help you track down the problem. http://antiqueradios.com/forums/viewtopic.php?p=1218240#p1218240

OK: I will run these checks. I did follow the emission checks stated in my manual using k and g leads in series with a 100k resistor but got no reading . I also checked all power resistors and wiring harness leads and they were ok.