Anyone have a good 10BP4 to sell?
I was given a GE "Locomotive" set and the CRT
is totally dead. I tried resoldering the base pins with no
improvement. I'm letting the filament run at 8 volts and will
see if there's any emission tomorrow. But if no success, I will need a good replacement.

Check with Harry Poster?

Yeah, that's where I got my 10BP4...Harry's a Good Guy, too...

Anyone have a good 10BP4 to sell?
I was given a GE "Locomotive" set and the CRT
is totally dead. I tried resoldering the base pins with no
improvement. I'm letting the filament run at 8 volts and will
see if there's any emission tomorrow. But if no success, I will need a good replacement.

I have a very strong one that needs the aquadag reapplied, other than that it can be yours cheap,if not I have one that tested good at about 400 on my B&K.

Thanks to all who replied, I have found a good one.