Any Ideas on what causes it to act like it is attempting to change channels on it's own. It only does it on the coax. The A/V 1, 2,3,4 feed from sat box DVD or VCR works fine unless going through the coax connector.
this is the Colortrack2000 StereoMonitor with the huge remote pad Any clues?

YES... It's usually bad solder connections in the system control module (MSC001, MSC027, etc). You have to take the tuner and controller assembly out (two 6-inch square by 1-inch thick shielded boxes, and unmate them from each other, then take the cover off the MSC module (the one withOUT the antenna inputs on it), and resolder the connector pins and all of the chassis ground connections. That's a very common problem, and an easy fix.

Charles

Thank you very much I will give it a try? Dose a pancil gun solder these well enough?

Thank you very much I will give it a try? Dose a pancil gun solder these well enough?

It should work just fine, good luck!

It should work just fine, good luck!

Well if I go wrong somewhere I can at least get a new hair do! Thanks!