#1
|
||||
|
||||
Wr-64a rca bar dot color generator
I have this rca wr-64a works fine but I’m sure it’s due for new power supply caps by changing these caps will this upset the alignment or calibration.
|
#2
|
||||
|
||||
Changing the electrolytic capacitors and the paper ones should not make too much of a change, and even if it does, https://bama.edebris.com/download/rca/wr64b/wr64b.pdf
Setup seems rather easy.
__________________
=^-^= Yasashii yoru ni hitori utau uta. Asu wa kimi to utaou. Yume no tsubasa ni notte. いとおしい人のために |
#3
|
||||
|
||||
Well I have the 64a shouldn’t be much different.
|
#4
|
||||
|
||||
Something that old is more likely than not in need of an alignment. Changing the caps shouldn't make that much of a difference.
|
#5
|
|||
|
|||
Here's a scan of the rear panel of my wr64 with the controls marked. That should give you a good starting point.
And while you're in there, you might want to install a fuse in the AC line input. Original WR64's did not have a fuse!
__________________
Last edited by kf4rca; 02-24-2024 at 07:19 AM. |
Audiokarma |
|
|