#1
|
|||
|
|||
CTC 16 Tint Out of Range
Tonight when I turned on the CTC 16 I noticed the tint was way off. It has shifted towards red. Before you could get a good picuture with it set in the Center. The Gray Scale is fine. So off the back goes. Anybody got any good sugestions
|
#2
|
||||
|
||||
check the 3.58 mhz oscillator tube. It may be acting up causing the color drift. The crystal could also be the problem.
__________________
Jordan |
#3
|
||||
|
||||
Quote:
|
#4
|
||||
|
||||
I wouldn't doubt it. Every color set I've worked on, especially philco and zenith had 6gh8 for the 3.58 oscillator. EIther the circuitry was just hard on the tubes or they were a poor design. I've never found a set that didn't have a dead or shorted one.
__________________
Jordan |
#5
|
|||
|
|||
Pretty sure its a 6GH8 in this set, I was so tired last night I didn't get a chance play around with it. I hope its the tube and not the crystal. Thanks for the tips.
|
Audiokarma |
#6
|
|||
|
|||
If it was the crystal I wonder if you could get good color at ANY point in the tint range(?)
|
#7
|
|||
|
|||
Tried another Tube, I got good picture now, but the tint control is all the way towards the green side.
|
#8
|
||||
|
||||
Sounds like it needs alignment for different tube capacitance?
|
#9
|
||||
|
||||
Center your tint, adjust the burst for good flesh on a reliable show, and enjoy.
|
#10
|
|||
|
|||
That was a very simple fix, thanks reeferman, The CTC 16 is back to normal,
|
Audiokarma |
|
|