|
#1
|
||||
|
||||
One caution. The service adjustments ( h-freq, V-lin, V-size ) are
very small & delicate. They also have lock tight on them often. SO go very easy on them ! Sounds like the electrolytic caps are bad in both the Hoz & Vert. It could also be just a dirty tuner. BTW the fine tune is multy turn. Could be that is way off. When you see the pix try turning it 1-2 turns CW & see what happens. Sometimes you also need to push it in too to engage the gears. 73 Zeno LFOD ! |
#2
|
|||
|
|||
May have made the mistake of fiddling with the knobs too much to begin with so I'm kind of starting with a clean slate. The Horizontal and Vertical knobs both mess with the wobbliness of the screen (the alignment?). I can get the screen almost centered then it just goes out of wack. I turned both of the knobs so that they're at the center location because that seems like roughly where the center point is. I go to adjust the horizontal frequency and I can almost get it just right but not quite.
The best I can get is the screen being slanted. I've adjusted it multiple times and the slant is always in the same direction too. Here's a video of my fiddling with stuff so you guys can see what I'm talking about. I don't know if it's all a problem with the TV or some stuff needs to be replaced. The knobs are unbelievably sensitive to touch. Sometimes just removing the screwdriver that I am using to turn them is enough to make the image more messed up. https://www.youtube.com/watch?v=0924Aq3syXc |
|
|