#16
|
||||
|
||||
I hate clowns!!! That tube would have freaked me the hell out - making me sell the set immediately! LOL!
__________________
-Al |
#17
|
||||
|
||||
Hard to tell if it is a clown. It looks a little like the Quaker Oats guy, which would fit in with the (William?) Penn tube brand.
|
#18
|
||||
|
||||
We have a winner!
|
#19
|
||||
|
||||
OK, I'll take that answer
Encountered my first open power resistor so far and replaced it. Also finished up the sync separator, vertical oscillator and output in this corner. This set is proving to be quite a challenge. I now have threes versions of the schematic and none quite match. They also really packed the components in. Done with the sound IF, ratio detector and output amp too. Last edited by bandersen; 08-24-2014 at 01:50 AM. |
#20
|
||||
|
||||
Done with the vintage table refinishing yet?
|
Audiokarma |
#21
|
||||
|
||||
Did you replace the grille cloth? Just noticing that the closeup picture shows the set with what looks like a gaping hole in the speaker area. Then the full view of the set there is no hole, but the cloth looks original.
__________________
"Face piles of trials with smiles, for it riles them to believe that you perceive the web they weave, and keep on thinking free" |
#22
|
||||
|
||||
Quote:
All I have at my place is the chassis. LOL Which one ? I'm just about done giving my danish modern coffee table a fresh lacquer recoat and rubbing out my Philco charside radio. Still haven't touched my vintage kitchen table Last edited by bandersen; 08-24-2014 at 02:08 AM. |
#23
|
||||
|
||||
#24
|
||||
|
||||
This sure has been a confusing chassis to work on but I'm getting close!
All the electrolytics have been rebuilt and I'm just waiting on some power resistors to arrive tomorrow. Meanwhile, I'm cleaning up the corroded chassis. I'm also reviewing all the components and finding some damage like this chipped ceramic disc. |
#25
|
||||
|
||||
What do you use to cut open those multi-section electrolytics so neatly without removing them. Or maybe you did remove them, but I figure if you did and then rebuilt them then you would re install them as units.
__________________
"Face piles of trials with smiles, for it riles them to believe that you perceive the web they weave, and keep on thinking free" |
Audiokarma |
#26
|
||||
|
||||
#27
|
||||
|
||||
Here's a closer look at one of the oddball resistors in this set. It's a Rosenthal which I think is German.
Last edited by bandersen; 08-31-2014 at 08:28 PM. |
#28
|
||||
|
||||
I have Seen these in a couple of 1950 Admirals that i have worked on
|
#29
|
||||
|
||||
I noticed the yoke in your video has Y17 printed on it, so it's probably a Thordarson replacement. Far as I can tell a Y13 and Y17 are very close(both 70 degree) with the exception that the 17 has the octal plug attached.
|
#30
|
||||
|
||||
I've got the knobs and the control panel/nameplate you need. PM sent.
__________________
Dumont-First with the finest in television. |
Audiokarma |
Thread Tools | |
Display Modes | |
|
|