#1
|
|||
|
|||
B&K 415 Probes
Got one in good working order but without the probes and cables. I'm concerned about the output jacks to the scope. I guess I'll have to fabricate something because I expected them to be standard BNC. I've looked on the bay for them but no luck so far. Does anyone have any suggestions on where I might find some or any suggestions on fabrication? Thanks,
|
#2
|
||||
|
||||
Is this what you're looking for?
https://www.ebay.com/itm/32562147297...BoCl1oQAvD_BwE |
#3
|
||||
|
||||
The only real probe is the demodulator probe. I had one demod probe before I had my 415 and I robbed the mike cable off it for something else....So when I got my 415 I just converted everything to BNC...It was surprisingly easy.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
#4
|
|||
|
|||
Quote:
|
#5
|
||||
|
||||
Or use these amphenol to BNC adapters. Hmm. Looks like you would need to cut down the center pin?
https://www.ebay.com/itm/125955958203 |
Audiokarma |
#6
|
||||
|
||||
Quote:
Those mic connectors aren't hard to change to BNC. Just a hot lead solder joint and a nut for ground and mechanical mounting. I had some spare BNC connectos off of a junked SS monitor and they bolted right in.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
#7
|
||||
|
||||
Quote:
I have changed the connector on several vintage instruments that I use, panel-mount BNC connectors are readily available and inexpensive. https://www.amazon.com/QMseller-Chas...s%2C330&sr=8-3 jr |
#8
|
||||
|
||||
Aren't the mounting holes smaller?
|
#9
|
||||
|
||||
IIRC they were both the same size (roughly the diameter of a standard potentiometer mounting hole IIRC). I remember literally unsoldering and unbolting mine then bolting in the BNC connectors (as is) and soldering the wire....It was surprisingly easy.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
#10
|
||||
|
||||
I had no problem mounting the BNC connectors on Heathkit equipment...no drilling, no shimming, they just bolted right in. Possibly other manufacturers equipment could be different
jr |
Audiokarma |
#11
|
|||
|
|||
I ordered the female BNC connectors to convert them. Following Bobs series on alignment very closely!
|
|
|