#16
|
|||
|
|||
No need to be sorry for the rant. It's true; people watch those shows and think that they have a fortune. If you look for the knobs from the people on here, you'll find that they are very fair with their prices.
|
#17
|
|||
|
|||
The largest crocks are filled with statements from the show, "Storage Wars". There is no way people are going to pay what they say the stuff is worth...
|
#18
|
||||
|
||||
The audio detector is also meaningless like AGC, the top of the tone control looks like a great location because it presents an input impedance to match
__________________
"When resistors increase in value, they're worthless" -Dave G |
#19
|
|||
|
|||
Problem is, I would be coupling directly into the audio output tube, Not sure it would have enough volume as most audio amps at least have a pre-amp tube?
|
#20
|
||||
|
||||
Good point, line output level of the source player is about 1 volt, and 1 K or 10 K impedance. An low input Z like an op-amp or transistor stage is needed. The 6JD8 detector stage output level needs to be duplicated to drive the output stage.
__________________
"When resistors increase in value, they're worthless" -Dave G Last edited by DavGoodlin; 01-05-2018 at 03:39 PM. |
Audiokarma |
#21
|
|||
|
|||
I am wondering if I could use the 6JD8 by itself as its of course going to have gain. Just need to disconnect the IF coming into it.
|
#22
|
||||
|
||||
IIRC that is what I did.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
Thread Tools | |
Display Modes | |
|
|