|
|
|
|
|
#1
05-12-2017, 04:05 PM
|
||||
|
||||
|
Quote:
__________________
|
|
#2
05-12-2017, 05:48 PM
|
||||
|
||||
|
Quote:
__________________
Brian USN RET (Avionics / Cal) CET- Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit!
|
|
#3
09-25-2017, 02:33 AM
|
|||
|
|||
|
It's been a while since I've updated this thread, thought I'd bring everyone up to speed on things. I changed the lone ceramic/paper-wax capacitor on the HV side. Still getting some horizontal warp on high contrast images (even with a weak signal) and have yet to find its cause. I have not performed an alignment yet, so far it yields visible lines up to 3.0MHz on a multiburst bar sweep pattern. Would an alignment produce a higher response?
Also I've noticed that the HV hum is EXTREMELY LOUD. Is this normal or is the flyback being over driven? lastly, thank you very much, Findm-Keepm, for the parts! So far I've installed the antenna and the UHF knob, but yet to install the V-hold knob as the "striptrol" is an absolute pain to get into x.x
|
 |
|
|
Hybrid Mode
