another cat removal

[DaveWM]

this time with water. a 21FJP22. I picked up a small kidde pool (baby really) at target for 5$ fits just right. I don't have my camera handy but will snap a pic later. I used a exacto to cut the tape seam righ at the lens, then peeled it off. the pva as not as hard as I have on some other sets, more like cheddar cheese, maybe ti will go a bit faster than the last one I did (a RCA rectangle, the PVA was much harder on that one. I did that one with the low temp low pressure method. Hopefully the somewhat softer pva will let the water soak in and do its thing in not too many days.

I have the water just above the glue line. I can see that I will have to keep an eye on it for evaporation losses. there is also a bath cloth under the lens, I dont think its needed since the plastic liner bottom shoule be enough to protect it from scratching. I have it on a concrete covered porch.