Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 08-19-2013, 04:51 PM
TinCanAlley's Avatar
TinCanAlley TinCanAlley is offline
Duck, you sucker!
 
Join Date: Sep 2008
Location: So Cal, CA
Posts: 718
Last post about my convergence

I know there is not such thing as perfect convergence on CRTs, especially older sets, but I need to get closer than I am. I'm used to seeing a little red or blue on edges of images, but they've always been less than an 1/8". What I'm dealing will on the right and left edges are separations of up to a 1/2" and covers 2" on the left side and 6" of the right.

I know it should get better than this. No one would buy a set if the convergence were this bad. Since I've done all the electrolytic caps, could it be a resistor or capacitor on the convergence board?

I'm attaching a pic. Don't pay attention to the bottom lines. Those are lined up now. I had then lined up, but made them that way when tried to get the edges better. The sides are still as messed up, but not the bottom center horizontal lines.
Attached Images
File Type: jpg convergence small.jpg (57.2 KB, 164 views)
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL

Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:48 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.