Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Vintage TV & Radio Tech Forum

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 05-27-2018, 02:03 AM
kramden66 kramden66 is offline
VideoKarma Member
 
Join Date: Nov 2010
Location: Rockaway, NJ
Posts: 1,414
Zenith TV chassis 16K20 horn and fly

The horizontal linearity is not quite right , it pulls a little on the left side of the screen and crushes a little on the right , since there is no Lin where do I look or what would cause this ? It's not the sleeve on the neck of the CRT because all that will do it push the picture in on both side.
Next is the flyback , it does get hot and I'm wondering if there is a pin on the Horizontal Output tube that I should be checking the ma on like one does with a color roundie or porthole ?
Reply With Quote
  #2  
Old 05-27-2018, 09:55 AM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,672
You check it at the cathode of the hoz output.
Break the connection, put mA meter in series. You also
need a cap across the meter IIRC a .01 but check
the manual.
Also check the G-1 voltage. If its less negative than spec
its usually a resistor in the horz osc or one of the tubes.

73 Zeno
LFOD !
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:23 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.