|
#1
|
||||
|
||||
Should I still check the HOT current even though I installed a 120mm fan on a fabricated metal cover I made? The fly gets warm to the touch but not too hot after being on for 45mins to an hour.
__________________
Admiral C322C2 Regent (Restoring) RCA CTC-7 Pensbury (Restored) RCA CTC-5 Westcott (Restored) CRA CTC--4 Director 21 (Restoring) |
#2
|
||||
|
||||
Does not matter (even if the set does not need the current checked) it should ALWAYS be checked when you get a set and the linearity/efficiency coil adjusted for minimum current.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
#3
|
||||
|
||||
What current level is considered safe for a CTC-5?
__________________
Admiral C322C2 Regent (Restoring) RCA CTC-7 Pensbury (Restored) RCA CTC-5 Westcott (Restored) CRA CTC--4 Director 21 (Restoring) |
#4
|
||||
|
||||
There's no hard and fast number for any set, you adjust for minimum reading on the meter.
__________________
Evolution... |
#5
|
||||
|
||||
As miniman said you want min current in operation, BUT there is usually a safe(ish) max that is published in the sam's for most sets (usually in the horizontal adjustment procedure). If over max after warm up assume something is wrong.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
Audiokarma |
#6
|
||||
|
||||
From where do I measure the current? Manual says the h out tube fuse holder is where the current can be measured I hooked up my 27fm and I am not getting anything....
__________________
Admiral C322C2 Regent (Restoring) RCA CTC-7 Pensbury (Restored) RCA CTC-5 Westcott (Restored) CRA CTC--4 Director 21 (Restoring) |
Thread Tools | |
Display Modes | |
|
|