Now onto some cleaning. I'm using a light application of Naval Jelly wiped down with a damp paper towel after a few minutes. Then a little spray of contact cleaner to flush out any remaining crud. I noticed Winky Dink came up with a
similar technique recently 
You can see how this chassis might have looked when new in the section that was protected.
Making progress.
The focus magnet and yoke supports cleaned up very nicely too.
I found this label on one of the tubes. That address is close to where I found the set.
Good thing I popped off the HV cage. One of the missing focus coil screws was hiding in there!
