|
So I might have just hit a "duh" moment here. Reading the barely-legible scanned print at the bottom of the schematic it says "channel selected shown in channel 13 position" and "measurements taken with no signal applied". And well, I had previously been testing voltages with a signal connected. Now, with no signal I get pretty close to all of the voltages on the schematic -- of course with a signal they jump up to those much higher ones.
Based on that, would it be safe to say then that what I'm seeing is in fact the correct, normal working voltages (despite being quite a bit different) when tuned in?
FK
Last edited by FrankieKat; 09-15-2017 at 12:25 PM.
|