View Single Post
  #4  
Old 01-25-2018, 08:48 AM
dieseljeep dieseljeep is offline
VideoKarma Member
 
Join Date: Jul 2010
Posts: 7,562
Quote:
Originally Posted by DavGoodlin View Post
Check the terminals on the horizontal waveform coil next to the 6CG7, just a bit of jostling on the board nearby can expose a cold solder joint
I would be a good practice to go over all the tube socket connections on both the front AGC, vert and horiz board. Also go over the ground connections on both boards and the rest of the tube sockets.
Another important area is to look over two wires that are on top of the color board around the 6GU7's. They corrode and crumble from the extreme heat. Remove them and relocate them to the bottom of the board.
Reply With Quote