Quote:
Originally Posted by bhegges
... I kept the probe set to 75 ohm[/LIST]... I assume I should adjust the specified coil to get the marker to fall on the pictured response curve in the correct place, but I can also adjust to simply get the highest or lowest scope response for the marker, doing this completely messes up the curve.
...
|
1) Exactly what probe are you setting to 75 ohms? Is this a scope input setting?
2) What do you mean by "fall in the correct place?" If the procedure says min or max at the marker, it means only that - the vertical position of the marker should be min or max. If the curve ends up looking wrong *at the end after all adjustments have been made*, there is something wrong with your setup or you made a mistake earlier in the procedure.
It is possible the curve won't look right when you are only part way done.