View Single Post
  #7  
Old 08-16-2017, 01:06 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,832
Quote:
Originally Posted by zeno View Post

I think these are pretty much the same. If its bad I would try one
that looks the same but check the pin out. You need ground, +5v & data out.

73 Zeno
LFOD !
Different - in pinout and electrically.

Looking from the top of the sensor, OP's is a mirror pinout of mine - swap the pins around and it would work if electrically the same, but.....his requires a "pullup" resistor (R3703 on his board), meaning it's a transistor output - the one I have is most likely a CMOS/FET output (direct connection to Standby 5V connection...). I was hoping....
__________________
Brian
USN RET (Avionics / Cal)
CET- Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!

Last edited by Findm-Keepm; 09-29-2017 at 06:39 PM.
Reply With Quote