Quote:
Originally Posted by Celt
If it uses a DC motor...and I assume it does...replacing the electrolytics in the servo area that controls the motor will correct that issue. It's a common problem on direct drive turntables.
|
huh
i'll have to find a schematic then...unless it's easy as just tracing the wires from the motor to the circuit board...
Never heard of this being an issue in ddt's.
Quote:
Originally Posted by Findm-Keepm
|
Actually, i've looked all that over a number of times and didn't find my problem/solution in the list.
BUT, the list did point me to the possibility of speed problems and is the reason why I tore it apart and cleaned the platter's spindle and re-oiled it...along with some other maintenance I did.