[DaveWM]

been no progress due to hand surgery, but I did manage a little bit of work just before.

1st pic if two of the completed can caps.
2nd pic is just some of the cleaned up PCB's so I can see what I am doing
3rd pic has the bone saw used to cut off the cans right at the shoulder and the pin vise used to drill the holes from the bottom side up. Drilling from the bottom lets me get the idea spot for the hole. One hole right by the pos terminal and then the other hole right by the soldered twist lug. Doing caps like this lets me use the cheaper radial lead caps and leaves the lead dress undisturbed. You just need to clean well so the solder will flow.