|
The wires connected to the power switch are connected and not loose.. the coils behind the plug where power cord plugs in look burnt out and broken winding on coil... I tested the tube again using my Sencore CR70.. When I go into emissions on each gun the needle jumps well into the good range and then slowly goes into the bad.. Does that each time testing each gun.. I go back into the cut off settings and the settings go off after testing... Think I should zap this tube using the BK or Beltron with the cleaning function, or should I wait and see what happens when the set is functioning and HV has been to it?
__________________
Looking for an all tube or hybrid color TV set from the late 1960s, early 1970s that's in a steal cabinet..
Last edited by tvcollector; 12-07-2014 at 08:31 PM.
|