well, learning everyday!!!, not used to the Ge but they seem to take more stress than the usual Si.
I have another question, in the Horiz osc. what are the elements that decide for the frequency, I realized that it never reaches 15750 Hertz, instead, it goes extremely low (below 5kHz) making the whole circuit noisy (scary!!) and the highest frequencies I can reach in 11 to 12 kHz.
I was misled by the sams doc showing only half the frequency but at the output of the
2sc41 I surely need 15750 Hz or close to this. Am I wrong???.
I measured all elements and they are within specs unless there is a mistake in the doc.
this set is a real challenge.
thank you again for all the tips
|