Quote:
Originally Posted by pac.attack76
No I didn't. Can u point those out to me?
|
The horiz output will be located on the right side of the chassis near the tripler. One of your pictures shows a metal TO-3 (top hat) transistor held to the side of the chassis near the yellow label with two 1/4" screws. If it's on the right side of the chassis, that's the output (if it's on the left, it's the reg). You can check from the metal body to the chassis ground side rail. It should read open (over 100K ohms). If it reads short (a few ohms or less), the transistor is shorted.
The low voltage regulator would be located on the left side looking from the back. That also might be a TO-3 metal transistor mounted like the horiz output is. That transistor won't be shorted to the ground panel but you can test it by removing it from the chassis and checking resistance between the metal body and the two terminals.
John