[ThePlague]

Hello all,

Sorry for the hiatus again. I've had time to spend a solid day working on this set. Items replaced before starting:

S-84384 coil (my slug broke inside)
212-72 rectifier (mine was cracked and falling apart)

I was able to replace all but the Chroma Duramodule with NOS modules that I happened upon.
I added another 2M ohm to the focus pot such that I can get to either side of out of focus and then center it. Personally I think its still blurry but that is either my expectations are a little high for the set.
I also noticed that the image is shifted to the right. I cannot find any horizontal position adjustments however.

Following the manual and advice I just cannot seem to get this set to align properly. My left and right sides are always out of alignment against the blue no matter what is tried. Convergence strips needed maybe? Below is the best I could get after about 4 hours. Given the age of the set, what level of compromise should I expect?