Thread
:
Westinghouse 17TV7C
View Single Post
#
66
10-09-2014, 10:57 AM
MIPS
VideoKarma Member
Join Date: Jun 2014
Location: West Canadia
Posts: 1,007
A new pot and replacing a pile of resistors I was finding out of tolerance removed the VBI oddity and the lack of height control.
The width control however is still completely dead. I've replaced or verified all the resistors immediately adjacent to it in the circuit and I know that any capacitors in the area that aren't mica are good because they've all been replaced. Both parts of the width coil have continuity so at the least it's not gone open but there's no spec on what resistance if any it should have. Any ideas? Anyone? Anyone??
Last edited by MIPS; 10-09-2014 at
11:00 AM
.
MIPS
View Public Profile
Visit MIPS's homepage!
Find all posts by MIPS