Quote:
Originally Posted by TinCanAlley
Thing is, I have to lift one end to remove it from the circuit for testing. I think I'll go the scope route and if that doesn't work, I'll live with the bars. I can see myself doing more damage if I start poking around with a big soldering gun.
|
Not to worry. I only used a gun to do filter cans & the grouned
lug of terminal strips. A pencil with the hottest tip will work on
the other lugs. We used the common weller station.
Alternative is snip off one end to test then tack back on
if OK. I always replace into the lug to keep it looking
neat & save time but thats just me.
BTW I dont know if its come up but the ground lugs on
Zeniths break off sometimes & go int. Poke each one with a
small screwdriver & resolder any that crack open.
73 Zeno
