|
Now I have no high voltage. I went to the shop today to run some tests then discovered a black screen. I tried the spark jump test and it for sure is dead. The damper, HOT, and high voltage rectifier all check good on my tube tester. Nothing red plates, nothing appears like it is getting hot. There is no wax puddles under the flyback. I'm not sure where to go next. I will probably need to pull the chassis, but I want to make necessary tests, if any, before I do that. I tested all the tubes and they all tested good. I can't see if the IF tubes are lit or not. I can barely see them light on the tube tester. They all have B+ on plate and screens. I have not checked filament voltage on the IF strip, but that's a good idea.
|