Thread: 1963 Philco
View Single Post
  #34  
Old 07-02-2008, 11:16 AM
JB5pro JB5pro is offline
VideoKarma Member
 
Join Date: May 2008
Posts: 616
I haven't seen this mentioned...

I expect it has been discussed but haven't seen it yet:
Is it not very important that the tube shields have a very good contact to the grounding tab that contacts them at the base? I had a funny color problem that got better when the shield made better contact. I was going to put deoxit on it but just polished the area and put a light CRC coat on it. I have seen some tube shields that had a ground wire soldered to them. I think that was mostly in Japan sets.
Reply With Quote