View Single Post
  #5  
Old 09-08-2016, 08:21 PM
Zenith6S321's Avatar
Zenith6S321 Zenith6S321 is offline
VideoKarma Member
 
Join Date: Aug 2010
Location: Charleston, West Virginia
Posts: 303
Installing the manual RF-IF output level DPDT toggle switch requires moving wires from the RF-IF switch to the DPDT switch. Here is how
1. Locate the back of the RF-IF switch. It looks like this


2. You need to wire the DPDT toggle switch like this


3. Remove these wires and label them. ONE AT A TIME.


4. Put some heavy tape (I used red duct tape) onto the front panel between the AUDIO and the RF-IF LEVEL switches


5. Put some tape on the back to catch the drill shavings


6. GENTLY drill a hole for the DPDT switch
Attached Images
File Type: jpg RF-IFswitchwires.jpg (71.1 KB, 219 views)
File Type: jpg SwitchDiagram.jpg (142.6 KB, 218 views)
File Type: jpg LabelWires.jpg (88.0 KB, 178 views)
File Type: jpg FrontTape.jpg (67.1 KB, 209 views)
File Type: jpg BackTape.jpg (88.9 KB, 210 views)
File Type: jpg HoleDrilled.jpg (56.6 KB, 215 views)

Last edited by Zenith6S321; 09-23-2016 at 07:30 AM.
Reply With Quote
Audiokarma