Thread: Rca ctc-5
View Single Post
  #45  
Old 09-29-2012, 02:32 PM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
did the remaining two filter cans, very easy method again. going to lay off it for a while now, then will get on the paper caps. There are quite a few that are point to point (the chorma section is NOT on a pcb) On those I am prob just going to go pig tail method. The tube sockets are not the best quality and I don't want to goof them up trying to unsolder. The others on the bottom have some coils involved so again pig tail. I know some purest think this is sloppy work, but I think its less invasive, and since I have no way of determining the operating status, I dont want to create a problem.
Reply With Quote
Audiokarma