View Single Post
  #13  
Old 06-13-2017, 10:01 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,832
Somebody plugged the boards together while powered up or mis-indexed them somehow. I've see that on the T922 scopes. Eats a resistor, and melts a transistor, IIRC. Pull the board, and do a junction check on all transistors - diode function on your DMM should do the job. On the power supply board, lift the base of each transistor before testing, as the low impedances/resistances on the board will give false readings.

Or open up another and cannibalize to make one good scope...
__________________
Brian
USN RET (Avionics / Cal)
CET- Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote