Zenith System 3 CRT help
Hello Zeno,
Thanks again for the information. I have pulled the HV board and found the cap you were referring to. It is a 4.7uF 315V and it has been replaced at least once before as can be seen from below. Someone got a little overzealous with the soldering iron and lifted the trace.
I noticed a label on the board that states "RE MFG IN MEX BY ZENITH" which could explain the repair. Therefore this is not the original HV board.
I need to place an order for another project and I will include this cap. Are there any others I should get as a just in case? Is the installed cap the correct value?
Regards,
Bobby
Last edited by rtsherrod81; 02-02-2021 at 10:49 PM.
|