View Single Post
  #6  
Old 02-15-2018, 06:49 AM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,657
Quote:
Originally Posted by teevee View Post
In some sets the convergence is part of the vertical output tube cathode circuit, disconnecting the board would reduce the sweep size... Easy enough to check on the schematic..
Good point. I dont remember if it was on these BUT some of the Zeniths
had 3 'lytics in the vert out. Usually they caused lin problems
( bottom pulled up) but on one chassis one of them caused strange symptoms.
V out transformers did go in Zeniths, not common but not rare. IIRC
several here have had to change them.

73 Zeno
LFOD !
Reply With Quote