View Single Post
  #6  
Old 10-21-2015, 08:18 PM
Arcanine's Avatar
Arcanine Arcanine is offline
VideoKarma Member
 
Join Date: Jan 2015
Location: Lake Geneva, Wisconsin
Posts: 281
Quote:
Originally Posted by Electronic M View Post
If all the leads exiting the windings are intact, and did NOT break off inside the windings, then they can be CAREFULLY soldered to phono pickup wire and reattached to the base lugs......I've done this before....3-4 years ago I forgot to unplug the CRT socket before pulling the chassis on my Silvertone CTC-15 clone, and they hoked and ripped the chroma osc transformer coil clean off. All the leads broke at points where I could tack new leads on to them, so I did that and glued the form back into it's base. Not the most elegant solution, but it works fine.
All the leads are there, looks like they broke off at the solder, not up at the coil. I don't think I have that level of skill to do that.
Reply With Quote