[StarquestMan]

sorry i took so long to get back to this thread. here are some more pictures i took unfortunately none are of a moving image because it was impossible to take a picture with my camera at the precise moment something would jump off/on screen but i did find some menus that had a bright section that would have a similar effect.

i haven't checked that 135v rail yet but i will definitely do that once i pop the set open again. is there a certain tolerance that is acceptable? i am very suspicious of the cap at c903 but i cant find any lying around that are high enough voltage so i will have to order it if it is in fact bad but i will check the 135v rail first. which brings me back to one of my original questions as to weather or not i should do a full recap of the set? also if i do will everything have to be completely re calibrated to compensate for the new caps or will it just be "better than original" and improve the overall sharpness and clarity of the set? i guess im wondering because i recently recapped an old pioneer and the improvement was huge and was wondering if tvs benefit in a similar way?

(quick update-i just tested the voltage between pin 6 and 5(gnd) on the FBT and got 136.3 volts so i assume this is fine?)