|
well im changing the rest of the caps and the set works great but the rolling problem,and when i set up the set it did not converge that well as there were a few of the pots that were turned all the way to get it close but was still off alittle so im changing the rectifier since im told they leak and could cause problems getting good convergence. also changing caps in and around the verticle section. yes it is a ctc15 and i dont have a scanner otherwise i would send the whole thing. the voltage dependant resistor next to the 6em7 vert tube i get no reading at all with it out of the circuit and the sams dont give a value of it i do see it in the schematic but no value what should be put in place of it if its bad, or does this resistor not show any reading?
|