View Single Post
  #19  
Old 09-03-2011, 10:41 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,832
CRT sets:

Selection sequence:

STAND-BY - MUTE - 1 -8 - 2 - POWER ON

2. The FACTORY MODE message will be displayed. The Factory Mode
has four components : Adjustment, MPX, PIP, Option Byte and Factory
Reset.
3. Access the Adjustment Mode by pressing the VOLUME keys
The adjustment parameters are listed in the accompanying table.
Select them by pressing the CHANNEL keys.
4. After completing the Factory Mode adjustments, turn the power switch
OFF.

Some sets have wierd names for stuff - like East-West Amplitude would be the Horizontal size, and East-West Centering would be Horizontal Centering. Others are for Pincushion, and use the same East-West nomenclature.

HS is generally Horizontal Shift, which can affect width.

Write down the parameter's value before adjusting, so you can come back to it if nothing is working.

Hope this helps,
__________________
Brian
USN RET (Avionics / Cal)
CET- Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote