Finished the vertical section today.
When I powered it up I still got good audio but still no video. I then tried direct video injection and after turning the H. Freq. adjustment I got a picture. Things are looking up.

I think I'll do the Video Amp section then roll onto the Audio next.

https://tvrestorerguy.com/wp-content.../100_9577a.jpg

https://tvrestorerguy.com/wp-content.../100_9578a.jpg

Completed some of the power supply section and the video amp section. The picture below is direct video injection to the video amp tube. Getting better.

https://tvrestorerguy.com/wp-content.../100_9594a.jpg

https://tvrestorerguy.com/wp-content.../100_9593a.jpg

I don't see any pictures on the last two posts... what's different? :scratch2:

jr

Crist,
All of your pictures for this thread disappeared yesterday on my computer.:scratch2:

Try and hit the 'Refresh" button.

No luck with the refresh button.

No luck here, either.... cleared my cache and lost all of the pictures on this thread. :scratch2:

jr

OK, I'll check with my IT guy and see what's up. Everything from my computer is fine. Don't ya just love it!

Pictures are working down through thread #25 here. I am using Chrome as the browser on a Win 10 machine.

Should be fixed by now! My IT guy is great!

THANK YOU! Seeing all pix again. :thmbsp:

jr

Completed the audio section today.
Tomorrow I think I'll do a little troubleshooting as to why I'm not getting any picture when running the signal through the IF section. Picture works great with video injection.

https://tvrestorerguy.com/wp-content.../100_9615a.jpg

https://tvrestorerguy.com/wp-content.../100_9616a.jpg

I need a little clarification on the alignment instructions.
I don't really understand what or how to hook up my test equipment. Maybe I'm a little tired.
The Sams instructions are below. What I don't quite understand is how do I continue to use my Eico 369 sweep generator to produce the 21.9MC signal and my demod cable? IT seemed to work for steps 6 and 7. But when I move the RF out cable and the Demod cable as in step 8, I still get the same waveform as in fig 3 and not fig. 4.


https://tvrestorerguy.com/wp-content.../100_9648a.jpg

https://tvrestorerguy.com/wp-content.../100_9650a.jpg