Monkey Wards Model 62-465 Dial Stringing Diagram Needed
Hello Everyone, I am currently working on a 6-Volt Storage Battery Radio from Montgomery Wards Model 62-465 that the dial string came unstrung (it didn't break it was just unstrung).
I'm trying to restring it and I've looked through the Riders Manual for this radio and it doesn't show a dial stringing diagram, and so I've been trying to restring it blindly without the help of a diagram and so far have not had any luck. I can get it strung up so that it will rotate the tuning capacitor with the tuning knob but then it gets hung up halfway because the tuning string where it comes out of the main pulley off the spring it attaches to snags on the side of the tuning knob bracket. Does anyone have access to a dial stringing diagram for this radio or have this model of radio that I could see a picture of how the dial string is strung up? Thannks for your help. |
Quote:
The set was built by Belmont! Check other Riders listings to see if there's another set that's similar. |
Quote:
|
I cant find that exact number in the HW Sams "dial cord stringing guide" DC-1 that shows a nice picture of several Airlines (Monkey Wards) with 62-4XX model number.
The same book shows a different set of arrangements for Belmont. Post a picture of the set to compare to one in the book. |
2 Attachment(s)
Quote:
It only has two pulleys the tuning knob shaft pulley and the tuning capacitor drive shaft pulley, and thats it. The tuning knob shaft is on a little bracket that screws to the tuning condenser assembly and the problem I'm having is trying to get the tuning dial string around that bracket without it rubbing against it. See Pictures Below. |
1 Attachment(s)
The schematic in Riders is no clue but good its there at all!
Closest match radio dial cord guide lists is an Airline 62-373 and 374, diagram 11 below. Radioatticachives.com shows a 62-375 set that looks similar. Attachment 202523 It looks as if an extra wrap on the dial side is needed so no string moves toward the bracket at either end of range. Dial string should be traveling past the bracket on both sides, but never unwinding off the tuner wheel to point it moves toward and contacts the bracket. |
Quote:
Quick question, should this radio be able to run off of a 6V Latern Battery? I'm asking because I've tried to hook it up to a 6V latern battery and the radio won't power on at all. |
Quote:
|
Quote:
|
Quote:
You have to use a 1000mfd or more across the output of the charger. Observe polarity! The set uses a synchronous vibrator. Anyone that has been in this game for any length of time, has a high current battery eliminator. I had my Knight-kit battery eliminator since I first started repairing radios over 60 years ago. :thmbsp: |
Quote:
|
Quote:
|
https://www.ebay.com/itm/COMBO-OF-2-...0AAOSwsc5e48Qg
Here's a pair of 6V 12AH batteries, buy these and put them in parallel and you've got 6V at 24AH available to your radio for under $30 shipped. Keeping them charged is then a simple matter of any of the multitude of cheap chargers also sold on the 'Bay ........ |
Quote:
|
Quote:
jr |
All times are GMT -5. The time now is 11:36 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.