1963 Zenith 29JC20 restoration
5 Attachment(s)
I picked up this Zenith 29JC20 last week at the Richmond Antique Radio and TV museum estate sale. My hope is to restore the set and use it daily. Here are some pictures of it before I get started. It's PVA has started turning green. I may attempt the cataract removal process if it affects the picture much. The cabinet is a little rough but not too bad. The service tag (PSI?? weight??) lists a bunch of service in the late 60's. The Picture tube is a 21FJP22A rebuild dated late 1973. Looks like its got the same tie-strap around the cloverleaf that I read about on other 29JC20s. Looks like some recent replacements of a few capacitors with orange-drops and only two small electrolytics. First I will check the picture tube with my slightly flakey CR70. Then I plan to shot-gun the old caps, the electrolytics, replace all the off value resistors, check the coils, and replace the bad tubes before I power it up. I am curious how this narrow band chroma set with RE phosphors looks compared to my 21CT55 with its 21AXP22A (my avatar/signature).
|
My very first concern with that set would be the integrity of the plastic/(nylon?) coil form of the H efficiency coil, which tends to crystalize over time and fall apart. If that happens, the requisite 'dip' in cathode current of the H output tube is lost, allowing the current to soar 'waay over spec.
|
Very nice.. These Zeniths seem to be popping up lately.. I wonder how the CRT is..
|
I'm going to be getting one in a few weeks, so this should be an interesting thread.
|
Quote:
Picture will be brighter for sure, but will you enjoy the colors as much as your wonderful 21CT55? Be interesting to see side-by-side photos when you are finished restoring the Zenith. jr |
Zenith sets do tend to have rather sharp monochrome detail, focus, and contrast...It can be so good that one can still think the picture looks good with moderate tint and gray scale miss-adjustment....Granted later roundys and rectangular Zeniths are what I'm familiar with. The only RCA based set that could hold a candle to it is my CTC-4, but the 4 don't get good color at the same fine tune point as monochrome, and the sound is best at a third spot so it could be an alignment fluke.
|
1 Attachment(s)
Quote:
|
I used a hair dryer to loosen them, then some gentle prodding with the twiddle stick is usually all it takes.
|
4 Attachment(s)
Quote:
|
Quote:
http://hdguru.com/hdmi-2-0-what-you-need-to-know/ I think its based on the human eye seeing B/W in higher resolution than color. Dave |
Quote:
Dave |
Quote:
If the three blue adjustment coils on the convergance board also have phenolic forms, you're doubly in luck. |
Quote:
|
Quote:
|
Quote:
|
All times are GMT -5. The time now is 02:12 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.